RE: [GP125] RS Base Gaskets

To Michael Bateman <xxxxx@xxxxx>, "'Paul Hoyt Nelson'" <xxxxx@xxxxx>
Date Thu, 9 Dec 1999 12:58:52 -0600
Cc "xxxxx@xxxxx" <xxxxx@xxxxx>
Sender xxxxx@xxxxx 


It varies up to .7mm/03inch.   That's a lot. 

Paul

I have quite a bit of gasket material that is very consistent. It has a 
tolerance of + or - .05mm for most materials, plus I check every sheet of 
material when I design a gasket. 
The only thing is I have yet to receive my first RS-125('92) and I have not 
inspected these gaskets. Can someone describe thsese base gaskets in full 
detail. 
I have metal and fiber materials but the thickness of these materials are 
limited. I have more of a selection with metal gaskets. 
I can get a sample from a friend of mine in town for the older RS-125s so 
this weekend I'll know for sure.E-mail the list with gasket details so I can 
track down any material or supplies I need to order duing the work week.

                                                Mike Thacker
Partial thread listing: